A science investigatory project (SIP) is a small piece of scientific research written up as a research paper. You ask a testable question, state a hypothesis, run a controlled experiment, analyse the data and report what you found. The parts of the write-up follow the same logic as a university lab report, so the habits it teaches carry straight into degree-level research.
In the Philippines, the Department of Education (DepEd) uses the term. In the 2014–15 guidelines we could open, its science fairs ran from school to division, regional and national level, and on to international fairs. If you’re starting a STEM degree after doing a science investigatory project, or mentoring one as a postgraduate, this guide is for you. It sets out the parts, works one example through all of them and shows how each part grows in a dissertation and a PhD thesis.
What does SIP mean in research?
In research, SIP stands for science investigatory project. DepEd offices use the abbreviation. A May 2023 advisory from Muntinlupa City’s division office passed on an invitation to a webinar series: ‘Learn How to Teach Science Investigatory Project (SIP)’.
An investigatory project is a piece of research in the full sense. It asks a question nobody has given you the answer to, and it tests that question with evidence. That separates it from a demonstration, where you repeat an experiment whose result is already known.
In DepEd’s 2014–15 national fair, SIPs were secondary-school projects. The guidelines for that National Science and Technology Fair state that ‘the competitions will be conducted among high school students only’. The fair also chose the student researchers who would represent the country at the Intel International Science and Engineering Fair (ISEF).
The same guidelines set research rules: a project may cover at most 12 continuous months, and plagiarism or fabricated data disqualify it.
What this means for you: if you did an SIP before university, you’ve already written in the shape a university lab report uses. The difference at university is depth, not shape.
Parts of a science investigatory project
Under DepEd’s 2014–15 fair guidelines, the science investigatory project format has four main documents, alongside the forms the fair requires. You write a research plan before you start and keep a project data book while you work. At the end come a research paper and a one-page abstract. The table below sets out what each part contains, taken from DepEd’s National Science and Technology Fair guidelines for 2014–15.
| Part | What goes in it |
|---|---|
| Research plan | The question or problem; goals, expected outcomes or hypotheses; detailed procedures; how you’ll analyse the data; a bibliography of at least five major references |
| Project data book | Dated notes of everything you did and measured, with units in every data table |
| Title page and table of contents | So a reader can follow the paper’s organisation quickly |
| Introduction | Your purpose, hypothesis, problem or engineering goal, what prompted the research and what you hoped to achieve |
| Materials and methods | What you did, in enough detail that someone else could repeat the experiment; only this year’s work |
| Results | Your data and analysis: statistics, graphs and your raw data |
| Discussion | Your results compared with theoretical values, published data or expected results; possible errors; what you’d do differently |
| Conclusions | A brief summary of the findings, stated as relationships between variables and supported by your data; practical applications; nothing new |
| Acknowledgements | Everyone who helped, including people and institutions |
| References | Every source that isn’t your own work |
| Abstract | At most 250 words: purpose, procedures, data and conclusions; no acknowledgements and none of your mentor’s work |
Source: DepEd, Guidelines on the National Science and Technology Fair 2014–2015 (enclosure to a 2014 DepEd memorandum, as published by DepEd Catanduanes). These are the most recent full national guidelines we could open.
A 2026 Imus City division memo cites DepEd Memorandum No. 006, s. 2026 for the 2025–26 national fair, but we couldn’t open that memo. Check the current memo for any competition you enter.
A DepEd Bohol guide, ‘The Making of Science Investigatory Projects’, sets out the same work as steps of the scientific method. Start a laboratory notebook, do the background research, construct a hypothesis and identify your variables. Then test the hypothesis by experiment. After that, analyse the data, draw conclusions and communicate the results in a final report, abstract and display.
If your template uses chapters instead
Your department, course or competition may set its own investigatory project format in chapters rather than the sections above. It might include headings such as the statement of the problem, the significance of the study or the scope and delimitations. If so, follow your template. The underlying parts are the same, just divided differently.
A worked science investigatory project example
The example below shows how each part of a science investigatory project depends on the one before. It describes a design, not real results.
Say you want to know whether used cooking oil can be cleaned for reuse by letting it settle (sedimentation) and pouring off the top layer.
- Research question. Does sedimentation reduce the solid particles in used cooking oil? It’s testable, and you don’t know the answer before you start.
- Hypothesis and null hypothesis. The hypothesis is your prediction: sedimentation reduces the particles. The null hypothesis says there is no effect: oil left to settle contains, on average, the same amount of particles as oil that isn’t. Your data then give you a reason to reject the null hypothesis, or they don’t. Writing both stops you from treating a hunch as a finding.
- Variables and controls. The independent variable is what you change (settling time). The dependent variable is what you measure (for example, the mass of sediment filtered from a fixed volume of the poured-off top layer). Unsettled used oil is the control and fresh oil gives a baseline. You keep the container, volume and temperature the same.
- Method. Write the steps so someone else could repeat them, and run several samples at each settling time rather than one. Record everything in your data book on the day you do it.
- Results. A table of measurements for each sample and settling time, then a graph. Say what the table and graph show, but save what the results mean for the discussion.
- Discussion and conclusion. Say whether the data support rejecting the null hypothesis, how large the effect was and what could have affected it. Then state the conclusion as a relationship between the variables. Don’t claim the oil is safe to reuse: you measured particles, not safety.
- Abstract. Write it last, in at most 250 words: what you asked, what you did, what you found and what it means.
Common mistake: describing the method you planned rather than the one you carried out. Newcastle University’s guidance on science reports makes the same point. The methods section ‘describes what you actually did rather than what you ideally intended to do’.
How is a science investigatory project judged?
DepEd’s 2014–15 fair guidelines include a project evaluation form that scores each project out of 100 on five criteria. It has columns for peer, teacher and expert evaluators. Creative ability and scientific thought carry 60 of the 100 points; clarity of presentation carries 10. So those two criteria together weigh six times as much as clarity.
| Criterion | Points | What the form asks (examples) |
|---|---|---|
| Creative ability | 30 | Is the question, approach or analysis original? |
| Scientific thought | 30 | Is the problem stated clearly? Are the variables defined and controls used correctly? Are there enough data to support the conclusions? |
| Thoroughness | 15 | Are the conclusions based on a single experiment or on replication? How complete are the project notes? |
| Skill | 15 | Did the student have the laboratory, computation and design skills the work needed? |
| Clarity | 10 | Are the purpose, procedure, data and results presented clearly? |
Source: DepEd, Project Evaluation Form (Enclosure No. 8), included with the 2014–2015 guidelines.
The same form asks whether the student recognises the data’s limitations and cites scientific literature rather than only popular sources. You’ll meet the same questions in research at university. That’s why a science investigatory project done well is good practice for degree-level work.
Science investigatory project vs lab report, dissertation and PhD thesis
An SIP, a lab report, a dissertation and a PhD thesis share one skeleton. Lab reports and longer science write-ups tend to follow a structure ‘often known as IMRAD’, as Newcastle University’s guide to structuring a science report explains. The letters stand for introduction, methods, results and discussion. What changes at each level is how much reading sits behind the work and how original it has to be.
| Science investigatory project | University lab report | Dissertation or research project | PhD thesis | |
|---|---|---|---|---|
| Structure | Introduction, materials and methods, results, discussion, conclusions, plus a research plan and data book | Abstract, introduction, methods, results, discussion, conclusion, references; appendices for large data sets | IMRAD, sometimes with a separate literature review and conclusion; an abstract at the start | Chapters; may have more than one results or discussion chapter |
| Literature | At least five major references in the research plan | References built into the introduction | A literature review with critical analysis of existing research | Deep knowledge and understanding of the field of study, defended in the oral examination |
| What it must show | A testable question answered with your own data | That you understand why the experiment was set, not just how to follow it | Why your research needs to be done, and what it found | An original contribution to knowledge |
Sources: DepEd NSTF guidelines 2014–2015; University of Sheffield, lab reports; Newcastle University, structuring a science report; QAA, Doctoral Degree Characteristics Statement (2020).
Two things grow the most. The first is the literature. In a short lab report, references are ‘integrated within the introduction’, according to Newcastle’s guide. In a longer project or dissertation, the reading and analysis can grow so much that it’s better given its own literature review.
The second is originality. The Quality Assurance Agency (QAA) says all UK doctorates require the main focus of the candidate’s work ‘to demonstrate an original contribution to knowledge’. That’s a higher bar than a science investigatory project sets. But the habit of asking a question no one has answered starts in the same place.
The methods keep the same aim: someone else must be able to repeat them. The University of Sheffield asks for a methods section clear enough that ‘someone else could follow’ it. What changes is the style: Sheffield also asks for the passive voice where possible (‘a sample was taken’, not ‘I took a sample’). Sheffield also says to follow ‘the specific guidelines issued with your experimental brief’, so check your department’s.
Analysis deepens too. Sheffield asks you to report any statistical tests using your subject’s conventions, so you’ll need to choose the right statistical treatment of your data.
The abstract is the part that changes least. The 250-word, purpose-method-results-conclusion abstract of an SIP is a good model for a dissertation abstract, though word limits vary by university. Our guide to writing a dissertation abstract covers the university version.
SIPs that reached international level
Investigatory projects can be serious research. DepEd’s guidelines reprint two abstracts from Philippine projects that won First Grand Awards at ISEF in 2002.
One, from Manila Science High School, tested liquid crystals as radiation dosimeters (devices that measure a dose of radiation) using cobalt-60 gamma radiation. The other came from the Integrated Development School of MSU-Iligan Institute of Technology. It isolated an antibiotic substance from toad parotid gland secretions and compared it with streptomycin and penicillin.

Mentoring a science investigatory project as a PhD student
If you do outreach alongside your PhD, mentoring an investigatory project is one way to do it. In the UK, the STEM Ambassador programme is one route in. UKRI’s 2024 tender notice calls it ‘the UK’s largest science, technology, engineering and mathematics (STEM) informal learning engagement programme for young people’.
You can read about other researchers’ lives during and after a PhD in our PhD interviews.
Four places where your experience helps:
- turning a topic into a testable question
- choosing controls
- keeping a dated data book
- writing a conclusion that claims no more than the data show
Under DepEd’s 2014–15 rules, a scientific review committee or institutional review board screens projects at school level before they go further. Projects involving human participants, vertebrate animals or potentially hazardous biological agents such as microorganisms need extra forms. Unless they’re exempt, they also need approval before the work starts. Projects using hazardous chemicals need a risk assessment completed first.
One rule matters for you as a mentor: the abstract ‘may NOT include’ work or procedures done by the mentor. Students are judged only on their own work, so guide the thinking, not the experiment.
What to do next
If you’re moving from an SIP to university research, start with the part that changes most: reading. Look at the types of research you’ll meet in your degree. Then see what goes into a full PhD thesis. There, the same structure has to carry an original contribution to knowledge.
Sources
- DepEd Bohol: The Making of Science Investigatory Projects
- DepEd Schools Division Office of Muntinlupa City: advisory of 17 May 2023, ‘Learn How to Teach Science Investigatory Project (SIP)’
- DepEd Schools Division Office of Imus City: Division Memorandum No. 099, s. 2026
- University of Sheffield: How to structure and write lab reports
- UKRI: STEM Ambassadors Programme, Find a Tender notice 008076-2024
- QAA: Characteristics Statement, Doctoral Degree (2020)
